Campbell-scientific OBS500 Smart Turbidity Meter with ClearSensor Tech Instrukcja Użytkownika Pobierz pdf (Strona 23)

OBS500 Smart Turbidity Meter with ClearSensor™ Technology

Diameter: 4.76 cm (1.875 in)

Length: 27 cm (10.625 in)

Weight: 0.52 kg (1.15 lb)

Maximum Cable Length: 460 m (1500 ft) (1 channel SDI-12 or

Analog); 15 m (50 ft) (RS-232)

7. Installation

If you are programming your datalogger with Short Cut, skip Section 7.3,

Datalogger/RTU Connection, and Section 7.6, Programming. Short Cut does

this work for you. See Section 4, Quickstart, for a Short Cut tutorial.

7.1 Default Settings

The OBS500 is configured at the factory with the default settings shown in

TABLE 7-1. For most applications, the default settings are used.

TABLE 7-1. Factory Settings

SDI-12/Analog SDI-12

SDI-12 Address 0

RS-232 Baud Rate 9600

Turbidity units TU

Temperature units Celsius

7.2 Device Configuration Utility

The Device Configuration Utility is used to change settings, set up the analog

sensor, enter RS-232 commands, and update the operating system.

Use the OBS500 test cable to connect the OBS500 to a computer running

Device Configuration Utility. The red wire is connected to a 12 Vdc power

supply and the black to ground. The datalogger power supply is a good choice

to use for the power supply. Device Configuration Utility software is shipped

on the Campbell Scientific ResourceDVD included with the OBS500.

The OBS500 is supported in our Device Configuration Utility

version 1.16 or higher.

NOTE

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Brak uwag

Campbell-scientific OBS500 Smart Turbidity Meter with ClearSensor Tech Instrukcja Użytkownika Strona 23