Campbell-scientific RAWS-P Remote Automated Weather Station Instrukcja Użytkownika

RAWS-P RemoteAutomated Weather StationRevision: 12/13 Copyright © 2006-2013Campbell Scientific, Inc.

RAWS-P Remote Automated Weather Station Specifications are available from our web site at www.campbellsci.com. For “sensors specifications,” click on

RAWS-P Remote Automated Weather Station CR1000KD packed in foam (may go here) FIGURE 2-1. Inside environmental enclosure (optional equipment shown)

RAWS-P Remote Automated Weather Station Use the CR1000KD Keyboard Display to see the “Public Variables” shown in TABLE 2-1. NOTE • Connect the CR100

RAWS-P Remote Automated Weather Station 19 Clockgood True or False: True after GPS fix and CR1000 clock has been set to match TX320 clock 20 TimeT

RAWS-P Remote Automated Weather Station 3.3 Precipitation A rain gage should be located over an open level area covered by short grass, or where gras

RAWS-P Remote Automated Weather Station 4.1.2 Wiring The HC2S3 attaches to the connector labeled TEMP/RH; this connector is color coded orange. This

RAWS-P Remote Automated Weather Station 4.2.3 Troubleshooting If a problem is suspected, check the sensor cable. Disconnect the connector and use a

RAWS-P Remote Automated Weather Station Consult the CS300-L manual for more information. NOTE 4.4 Wind Speed and Direction 4.4.1 Wind Sensor 4.4.1.1

RAWS-P Remote Automated Weather Station 4.4.2 2-D WindSonic 4.4.2.1 General Description The Gill Instruments 2-D Sonic Wind Sensor (pn WindSonic4-LQ

RAWS-P Remote Automated Weather Station 4.5.2 Wiring The CS100 is mounted inside the RAWS environmental enclosure and the sensor wires are attached t

RAWS-P Remote Automated Weather Station of a Ponderosa pine dowel with a bored hole and a Model 107 Temperature Probe inserted into the dowel. The CS

RAWS-P Remote Automated Weather Station The solar panel selected for the RAWS depends on the station power requirements, specifically the communicatio

RAWS-P Remote Automated Weather Station FIGURE 5-1. 12 volt charger/regulator 5.2.2 Wiring The leads from the RAWS connector panel “BATT CHARGER/SO

RAWS-P Remote Automated Weather Station 5.2.3 Troubleshooting If a problem is suspected, the CH100 may be checked by measuring: • input voltage bet

RAWS-P Remote Automated Weather Station 5.3.3 Troubleshooting If a problem is suspected, measure the +12 V and Ground terminal on the CR1000 printed

RAWS-P Remote Automated Weather Station FIGURE 5-2. GOES transmitter 5.4.2 Wiring The TX320 is mounted inside the RAWS environmental enclosure and

RAWS-P Remote Automated Weather Station 5.4.3 Troubleshooting If a problem is suspected, the TX320 may be checked by measuring the +12 V and Ground t

RAWS-P Remote Automated Weather Station 5.5.2 Wiring The CR1000 Keyboard/Display (pn CR1000KD) connects to the CR1000 PC board “CSI/O” 9-Pin connecto

RAWS-P Remote Automated Weather Station FIGURE 5-5. Printed circuit board wiring panel connector ID 5.6.2 Wiring The CR1000 is mounted inside the R

RAWS-P Remote Automated Weather Station performance testing (for example, bearing torque), and sensor component replacement, generally requires sendin

Warranty “PRODUCTS MANUFACTURED BY CAMPBELL SCIENTIFIC, INC. are warranted by Campbell Scientific, Inc. (“Campbell”) to be free from defects in materi

RAWS-P Remote Automated Weather Station in FIGURE 9-3. Note that when a negative number is subtracted from a positive number, the resulting arithmeti

RAWS-P Remote Automated Weather Station FIGURE 9-2. A declination angle east of True North (positive) is subtracted from 360 (0) degrees to find Tru

RAWS-P Remote Automated Weather Station 9.2 USGS Web Calculator The USGS provides an easy way of determining the declination of a specific site. Sin

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Assistance Products may not be returned without prior authorization. The following contact information is for US and international customers residing

Table of Contents PDF viewers: These page numbers refer to the printed version of this document. Use the PDF reader bookmarks tab for links to spec

Table of Contents 5. Equipment Wiring and Troubleshooting...12 5.1 Solar Panels ...

Table of Contents Tables 2-1. Public Variables ...4 4-1. TEMP/RH Conn

Table of Contents iv

RAWS-P Remote Automated Weather Station 1. Introduction The RAWS-P is the core of a permanent station. It consists of a CR1000 datalogger and 12 Vd