Campbell-scientific RAWS-P Remote Automated Weather Station Instrukcja Użytkownika Pobierz pdf (Strona 15)

RAWS-P Remote Automated Weather Station

4.1.2 Wiring

The HC2S3 attaches to the connector labeled TEMP/RH; this connector is

color coded orange. This sensor is internally wired from the RAWS connector

panel to the CR1000 datalogger.

TABLE 4-1. TEMP/RH Connector (color coded orange)

Connector Pin Description CR1000 Terminal

A Temperature H 1L

B Sensor Excitation VX1

C Sensor Signal L/

D Power Ground G

E RH Signal 1H

F Switched 12 V SW_12V

4.1.3 Troubleshooting

If a problem is suspected, check the sensor cable. Disconnect the connector

and look for damaged pins. Verify that the sensor body is connected to the

sensor head. Under the filter assembly, verify the sensors are connected but

not touching. Try connecting a substitute sensor. Obtain an RMA number

before returning this sensor to Campbell Scientific for repair.

Consult the HC2S3-L manual for more information.

NOTE

4.2 Rain Gage

4.2.1 General Description

The Texas Electronics Rain Gage (pn TE525-LQ) is an adaptation of a

Weather Bureau tipping bucket rain gage. The rain gage has a 6 inch collector.

The rain gage sensor output has a switch closure for each bucket tip. Level the

rain gage.

4.2.2 Wiring

The TE525-LQ attaches to the connector labeled PRECIP; this connector is

color coded blue. This sensor is internally wired from the RAWS connector

panel to the CR1000 datalogger.

TABLE 4-2. PRECIP Connector (color coded blue)

Connector Pin Description CR1000 Terminal

A Tipping Bucket C6

B 5 V 5V

C Ground G

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Brak uwag

Campbell-scientific RAWS-P Remote Automated Weather Station Instrukcja Użytkownika Strona 15