Campbell-scientific Sentek EasyAG Installation Guide v 3.0 Instrukcja Użytkownika Pobierz pdf (Strona 30)

Installing EasyAG 80 probes

2. Using a sledgehammer, beat the AMS soil sampler into the ground until the beating head is just

above the stabilization plate. (While it is preferable to go all the way in one insertion, successful

installation may be possible in heavier soils with 2 insertions). Ensure accurate blows are made such

that lateral deflection of the soil sampler is minimized. Do not compress the soil with the final blow.

Warning

Do not compress the soil such that normal water infiltration is inhibited

3. Turn the AMS soil sampler one single complete rotation.

4. Carefully lift the AMS soil sampler directly out of the ground. To remove the soil collected in the soil

sampler, simply beat on its side with the hand or foot. The design is such that the soil core taken is

slightly compressed, and of a lesser internal diameter than the soil sa mp l er itself. In heavier textures,

the soil sampler cleaning tool is used to clear the soil sampler by simply screwing it into the

compressed soil. The extracted soil should be deposited away from the probe si te.

Warning

If you experience difficulties at this point, remove the soil sampler in stages, or

obtain extra assistance to avoid back injury.

5. Remove the soil sampler polyguide.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Brak uwag

Campbell-scientific Sentek EasyAG Installation Guide v 3.0 Instrukcja Użytkownika Strona 30