Campbell-scientific SDM-AO4 4-Channel Continuous Analog Output Module Instrukcja Użytkownika Strona 1

SDM-AO4 Four Channel AnalogOutput ModuleRevision: 4/0912VC1C2C3AO1AO2AO3A04SDM-AO44 CHANNEL ANALOG OUTPUTMADE IN USASN: 2270Copyright © 1986-2009Camp

SDM-AO4 Four Channel Analog Output 6. Programming This section is for users who write their own datalogger programs. A datalogger program can be gen

SDM-AO4 Four Channel Analog Output SDMAddress: The SDMAddress parameter defines the address of the SDM-AO4 to which a voltage should be applied. Vali

SDM-AO4 Four Channel Analog Output Equation for CR5000: bit_rate=INT(k*20)*Resolution Where: k= the value entered in BitPeriod Resolution=50 nsec. 6.

SDM-AO4 Four Channel Analog Output 6.3.1 CR5000 Program Example Although this program is for a CR5000 datalogger, programming for other CRBasic datal

SDM-AO4 Four Channel Analog Output 6.3.2 CR10X Program Example Although this program is for a CR10X, programming for other Edlog dataloggers is simi

SDM-AO4 Four Channel Analog Output 5: If time is (P92) 1: 0 Minutes (Seconds --) into a 2: 1 Interval (same units as above) 3: 10 S

SDM-AO4 Four Channel Analog Output 12 16: Z=X+F (P34) ; Add 360 to the current reading 1: 9 X Loc [ WD_0_540 ] ; otherwise, the current r

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Warranty and Assistance The SDM-AO4 FOUR CHANNEL ANALOG OUTPUT MODULE is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials a

SDM-AO4 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab f

SDM-AO4 Four Channel Analog Output 1. Function The SDM-AO4 is designed to output four continuous voltages at levels set by a Campbell Scientific data

SDM-AO4 Four Channel Analog Output 4. Physical Connections Figure 1 shows the front panel of the SDM-AO4. The terminal block on the left is used for

SDM-AO4 Four Channel Analog Output FIGURE 1. Front Panel of the SDM-AO4 TABLE 1. Description of Terminal Block Connections Datalogger Connections 1

SDM-AO4 Four Channel Analog Output The SDM-AO4 has sixteen possible addresses, as shown in Table 2. The address for an SDM-AO4 is hardware selectable

SDM-AO4 Four Channel Analog Output FIGURE 2. Locational Diagram for the Address Jumpers. 5