Campbell-scientific HMP50 Temperature and Relative Humidity Sensor Instrukcja Użytkownika

HMP50 Temperature andRelative Humidity ProbeRevision: 10/09Copyright © 1995-2009Campbell Scientific, Inc.

HMP50 Temperature and Relative Humidity Probe Black Temperature Signal White Relative Humidity Signal Blue Signal & Power Reference Br

HMP50 Temperature and Relative Humidity Probe The temperature and relative humidity signals from the HMP50 are measured using two single-ended analog

HMP50 Temperature and Relative Humidity Probe BeginProg Scan(5,Sec,1,0) 'HMP50 Temperature & Relative Humidity Sensor measurements AirTC a

HMP50 Temperature and Relative Humidity Probe 6. Long Lead Lengths Long lead lengths cause errors in the measured temperature and relative humidity.

HMP50 Temperature and Relative Humidity Probe When the air temperature increases, so does the saturation vapor pressure. Conversely, a decrease in ai

HMP50 Temperature and Relative Humidity Probe 'CR1000 Public AirTC Public RH Public VP DataTable(Table1,True,-1) DataInterval(0,60,Min,0) Ave

HMP50 Temperature and Relative Humidity Probe ;Limit the maximum value of relative humidity ;to 1 (expressed as a fraction). ; 03: If (X<=>F) (

HMP50 Temperature and Relative Humidity Probe Shipping Cap(remove prior to installation)Protective Cap and Filter 9598 RH ChipFIGURE 6. Exploded Vie

HMP50 Temperature and Relative Humidity Probe 14

Warranty and Assistance The HMP50 TEMPERATURE AND RELATIVE HUMIDITY PROBE is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materia

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

HMP50 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for

HMP50 Table of Contents ii Tables 1. Recommended Lead Lengths... 1 2. Datalogger C

HMP50 Temperature and Relative Humidity Probe 1. General The HMP50 Temperature and Relative Humidity probe contains a Platinum Resistance Temperature

HMP50 Temperature and Relative Humidity Probe 2.1 Temperature Sensor Sensor: 1000 Ω PRT, DIN 43760B Temperature Measurement Range: -40°C to +60°C T

HMP50 Temperature and Relative Humidity Probe 3. Installation 3.1 Siting Sensors should be located over an open level area at least 9 m (EPA) in dia

HMP50 Temperature and Relative Humidity Probe Yellow Shipping Cap (remove before installation) FIGURE 1. HMP50 as Shipped FIGURE 2. HMP50 and 4130

HMP50 Temperature and Relative Humidity Probe FIGURE 3. HMP50 and 41303-5A Radiation Shield on a CM202 Crossarm FIGURE 4. HMP50 and 41303-5A Ra